Electronics LP-24 Manuel d'utilisateur télécharger pdf (Page 9)

Fig. 10 The adapter plates should be

installed onto the MagnaValve and the

assembly installed as a single unit. The

entire MagnaValve assembly can be

temporarily positioned and held into

place by using vise-grip or similar pliers

and then the bolts can be installed and

tightened.

Fig. 11 The feed spout can now be rein-

stalled easily, since it bolts directly to the

adapter plate. Be sure to use a rubber gas-

ket between the adaptor plate and the feed

spout. Do not use silicon or any other adhe-

sive that will make it difficult to remove the

valve for inspection.

Fig. 10

Fig. 11

Note: Adding a nonmetallic 1” spacer

above and below the MagnaValve will

improve MagnaValve performance.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Electronics LP-24 Manuel d'utilisateur Page 9